The SC40+TPSE(E) kit is designed to supply you with all you need to carryout a standard Dual Battery System installation, with the Auxiliary battery being mounted in the Engine bay plus additional parts, supplied with the kit, to add two new permanently powered cigarette light power sockets in the rear of the vehicle, powered from the auxiliary battery to make sure you never accidentally flatten your cranking battery.

The SC40+TPSE(E) kit includes an SC40 Smart Charger Dual Battery Controller, cable, battery terminal clamps, additional circuit breaker, two in-line fuse holders, two power sockets and all the hardware you required, except the auxiliary battery, battery hold down and if needed, a battery tray.

The SC40+TPSE(E) is designed to fit any car or 4x4 and the kit includes comprehensive installation instructions, designed to help even the more novice of DIY installers.

To separately buy all the parts contained in this kit will cost you over $270, so our kit price of $235 will save you at least $35 and as the kit has everything in it, you will also save lots more by not having to run around chasing all the parts.

SPECIAL NOTE, The (E) on the end of the SC40+TPSE(E) Part Number indicates this kit is for an (E)ngine bay Auxiliary battery installation. If you are planning to fit your Auxiliary battery in the rear of your vehicle then you will need to install the SC40+TPSE(R) kit. This kit contains heavier cable needed to be able to properly charge a rear mounted Auxiliary battery.